Help Irongeek.com pay for bandwidth and research equipment:
Man page of AIRMON-NG
Section: User Commands (1)
Updated: April 2010
Index of this MAN page
Back To MAN Pages From BackTrack 5 R1 Master List
airmon-ng - bash script designed to turn wireless cards into monitor mode.
<start|stop> <interface> [channel]
is script can be used to enable monitor mode on wireless interfaces. It may also be used to go back from monitor mode to managed mode. Entering the airmon-ng command without parameters will show the interfaces status.
It can list/kill programs that can interfere with the wireless card and set the right sources in /etc/kismet/kismet.conf too.
- start <interface> [channel]
Enable monitor mode on an interface (and specify a channel). Note: Madwifi-ng is a special case, 'start' has to be used on wifi interfaces and 'stop' on ath interfaces.
Disable monitor mode and go back to managed mode (except for madwifi-ng where it kills the ath VAP).
- check [kill]
List all possible programs that could interfere with the wireless card. If 'kill' is specified, it will try to kill all of them.
This manual page was written by Adam Cecile <firstname.lastname@example.org> for the Debian system (but may be used by others).
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 or any later version published by the Free Software Foundation
On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL.
- OPTIONAL PARAMETERS
- SEE ALSO
This document was created by
using the manual pages.
Time: 07:34:21 GMT, September 13, 2011
Printable version of this article
15 most recent posts on Irongeek.com:
If you would like to republish one of the articles from this site on your
webpage or print journal please contact IronGeek.
Copyright 2019, IronGeek
Louisville / Kentuckiana Information Security Enthusiast